Leaking Tap Repair in Concord

A tap dripping once every few seconds might not sound urgent, but the volume sneaks up on you: left running, that steady drip adds up to serious litres over a day, all before anyone thinks to glance at the water bill.

A tap refusing to fully shut off has an internal part giving out underneath the handle, and getting to it is rarely a big job.

Washers. The older-style compression tap relies on a small rubber disc that hardens over the years; put in a fresh one and the drip typically stops there and then.

Cartridges. Modern mixer taps swap the washer setup for a ceramic disc unit, and a scored or worn disc is usually why the handle won't seal properly anymore.

Seals. Dampness gathering around the handle or base, without any water actually leaving the spout, generally traces to a seal that's given out rather than the washer itself.

Buying whatever part happens to fit is a false economy: a generic swap that doesn't match the tap's exact model is the usual reason a repair undoes itself within a season, so we carry brand-correct stock rather than guessing.

Full tap swaps. Very old taps sometimes drip from wear in the tap body itself, not any single part inside it, and honesty means telling you when replacement beats another patch job.

A big share of the bathroom and kitchen taps around Concord are original to the house, still doing the job decades after most similar fittings elsewhere would've been swapped out.

Homes built through the 1920s to '40s often still carry their first-ever taps and mixers, predating the ceramic cartridge entirely, so we're frequently hunting down a part to suit a genuinely old fitting rather than grabbing whatever's on the shelf.

The newer unit blocks near Majors Bay Road run current mixer taps by contrast, and there the fault sits with a worn cartridge far more often than a washer.

Knowing broadly what era of fitting we'll be facing before we set off means the correct part is already on board, not something we go and source after opening the tap up.

1. First: get the water off at the meter, if you can reach it safely. We'll talk you through this on the call before we've even left.
2. We arrive and isolate the problem properly, working the leaking tap repair issue back to its actual source, not just the visible leak.
3. We'll tell you exactly what's wrong and the best way to fix it, then fair, upfront pricing before any work starts.
4. Repaired, pressure-tested and cleaned up. Quality Workmanship Guaranteed on every leaking tap repair.

A simple internal-part swap typically wraps up well under an hour once we're on site; a fitting no longer in production sometimes stretches that out while we match the part correctly.

Nobody rushes to book a dripping tap in, which is exactly why fair pricing matters more here than any sense of urgency.

15+ years' experience means we've matched parts to almost every tap brand sold in Sydney over that time. Every repair carries the Lifetime Labour Warranty, standing long after the van's gone.

We'd rather quote it straight and let the price speak for itself than talk anyone into urgency that isn't really there. A tap repair booked calmly, at a time that suits you, gets exactly the same standard of work as anything we treat as urgent.